Fagor 8055i FL EN - OPERATING IN JOG MODE; Operation in path-jog mode; Considerations about the jog movements

Operating manual
CNC 8055
CNC 8055i
OPERATING IN JOG MODE
2.
·TC· OPTION
SOFT: V02.2X
·45·
Jog movement
Operation in path-jog mode
The "path jog" mode is only available with the X axis keys. When pressing one of the keys associated
with the X axis, the CNC behaves as follows:
The rest of the jog keys always work in the same way, whether "path jog" is on or off. The rest of
the keys move only the axis and in the indicated direction.
The movements in path-jog may be aborted by pressing the [STOP] key or setting the jog switch
to one of the handwheel positions.
Considerations about the jog movements
This mode assumes as axis feedrate the one selected in jog mode and it will also be affected by
the feedrate override switch. If F0 is selected, it assumes the one indicated by machine parameter
"JOGFEED (P43)". This mode ignores the rapid jog key.
Path-jog movements respect the travel limits and the work zones.
Switch position Path-jog Type of movement
Continuous jog Deactivated Only the axis and in the indicated direction
Activated Both axes in the indicated direction and along the indicated path
Incremental jog Deactivated Only the axis, the selected distance and in the indicated direction
Activated Both axes, the selected distance and in the indicated direction,
but along the indicated path
Handwheel It ignores the keys.