·106·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Taper turning cycle
When changing the machining direction, the CNC changes the icon and shows the corresponding
help screen.
Finishing stocks in X-Z.
Either a single residual stock may be defined that is applied depending on the cutter's edge or 2
different ones, one for each axis (X, Z). It is selected with the following icon located in the finishing
area.
• The figure on the left applies a finishing stock depending on the cutter's edge. The finishing stock
is measured on the tool's cutting edge.
• The figure on the right lets define 2 finishing stocks, one per axis, regardless of the type of tool
used.
To select the type of finishing stocks, place the cursor over this icon and press the two-
color key. To define these residual stocks, place the cursor on the corresponding data,
key in the desired value and press [ENTER].
To Next Page
Loading...
