·108·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Taper turning cycle
Considerations
How to leave out the roughing or finishing operations.
By selecting T0 as the roughing tool, the cycle does not execute the roughing operation. This means
that after approaching the finishing operation will be carried out.
By selecting T0 as the finishing tool, the cycle does not execute the finishing operation. In other
words, after the roughing operation, the tool will move to the approach point maintaining the safety
distance from the theoretical corner.
To Next Page
Loading...
