Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; Reversal of the starting and final point of the face thread repair

Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·123·
Threading cycle
Asymmetrical cutters with two tips:
In the case of asymmetrical tools, the entry angle must always be respected.
The tool data CUTA and NOSEA must be entered correctly according to the calibrated tip.
Reversal of the starting and final point of the face thread repair
This feature is only used on face threads; i.e. in threading level 3 and in face thread repair level 4.
Set bit 13 of general parameter COCYF6 (P153) = 1 to enable this option.
h
H
Punta calibrada
10º 3º
CUTA=93
NOSEA=87

< -3º y

> -10º
Punta calibrada
CUTA=100
NOSEA=80
10º 3º

< -3º y

> -10º