Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; Level 3. Multiple drilling cycle.; Level 4. Multiple threading cycle.; Level 5. Multiple slot milling cycle.

Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·147·
Drilling and tapping cycles
Level 3. Multiple drilling cycle.
Multiple drilling can be done on the cylindrical side of the part or on its face. The following data must
be defined:
• The coordinates of the starting point.
• The total depth.
• The dwell at the bottom.
• The angular position of the holes.
• The total number of holes.
Level 4. Multiple threading cycle.
Multiple threading can be done on the cylindrical side of the part or on its face. The following data
must be defined:
• The coordinates of the starting point.
• The total depth.
• The angular position of the threads.
• The total number of threads.
Level 5. Multiple slot milling cycle.
Multiple slots may be milled out on the side of the part or on its face. The following data must be
defined:
• The coordinates of the starting point.
• The dimensions of the slot.
• The angular position of the slots.
• The total number of slots.