Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·157·
Profiling cycle
For a rounded corner, define the rounding radius (R); for a chamfer, define the distance from the
theoretical corner to the chamfer point (C).
Deleting all the points of a profile.
Once all the desired points have been programmed, they may all be erased at once. To delete all
the programmed points at the same time, proceed as follows:
• Place the cursor on the text "DEF. PROFILE (max 12 points)" of the window where the points
are edited.
• In the instant the cursor is placed in this position, the text changes to: "CLEAR - Delete all the
points".
• At this moment, pressing [CLEAR] displays a window requesting confirmation to delete all the
points: Press the [ENTER] to delete all the points or [ESC] not to delete them.
To Next Page
Loading...
