Fagor 8055i FL EN - Y AXIS; Level 2: Tool calibration with probing cycles.; Level 3: Probe calibration.

Operating manual
CNC 8055
CNC 8055i
Y AXIS
4.
·TC· OPTION
SOFT: V02.2X
·179·
Tool calibration
Level 2: Tool calibration with probing cycles.
Selecting the tool calibration using probing cycles shows, with Y axis, the following screen:
The < Y > icon turns on or off the display of the probe's Y coordinates at the bottom of the screen.
When selecting "display the Y axis", the calibration is also carried out on this axes. The Y axis
coordinates will be displayed by default.
Level 3: Probe calibration.
Selecting the probe calibration shows, with Y axis, the following screen:
The < Y > icon turns on or off the display of the probe's Y coordinates at the bottom of the screen.
The Y axis coordinates will be displayed by default.