CNC 8055
CNC 8055i
·TC· OPTION
SOFT: V02.2X
6
·185·
SAVING PROGRAMS
Part-programs may be edited, simulated and executed.
Each one of these programs is made up by concatenating simple operations or cycles and/or blocks
edited in ISO code. Chapter "3 Working with operations or cycles" describes how to edit or define
those operations or cycles.
This chapter indicates how to operate with those part-programs through the following sections and
sub-sections.
• List of saved programs.
• Seeing the contents of a program.
• Editing a new part-program.
• Saving an ISO block or a cycle.
• Deleting a new part program.
• Copying a part-program into another one.
• Modifying a part-program.
• Managing programs using the explorer
To Next Page
Loading...
