Operating manual
CNC 8055
CNC 8055i
OPERATING IN JOG MODE
2.
·TC· OPTION
SOFT: V02.2X
·57·
Tool calibration
Tool calibration
Place a part of known dimensions in the spindle and define its dimensions in the left window.
To measure the tool, the tool must be selected on the machine. If it is not, press the [T] key, key in
the desired number of the tool to be calibrated and press [START].
Measuring the tool.
1. Approach the tool to the part, touch it with it along the X axis and press [X] + [ENTER].
2. Approach the tool to the part, touch it with it along the Z axis and press [Z] + [ENTER].
The tool has been calibrated. The CNC updates the X, Z data and sets the I and K to 0. The actual
tool length is (X+I) and (Z+K); the "I" must be given in diameter.
Modifying the tool data while executing a program
It is possible to modifying the tool values (dimensions and geometry) without interrupting the
execution of a program.
To exit this screen, press [ESC].
To do that, press the tool calibration key. The CNC will show the tool calibration screen
with all the data for the active tool and it will allow modifying its data or of any other tool.
To Next Page
Loading...
