·70·
Operating manual
CNC 8055
CNC 8055i
2.
OPERATING IN JOG MODE
·TC· OPTION
SOFT: V02.2X
Spindle control
7. Spindle gear currently selected.
To select another gear, when not using an automatic tool changer, press the [S] key and then
use the [] key until the current value is highlighted.
Enter the gear number to be selected and press [ENTER] or [START].
8. Spindle angular increment when working in spindle orientation mode.
To select another value, press the [S] key three times. The CNC highlights the current value.
Enter the new value and press [ENTER].
Working with spindle orientation
When having spindle orientation, the CNC uses the same screen when working in RPM mode and
when working in spindle orientation mode.
RPM mode.
Press one of these three keys to select this mode. The screen will not show the angular position
of the spindle.
Spindle orientation mode
Press the key for spindle orientation to select this mode:
The spindle will stop (if it was turning), it then searches home and finally positions at the angular
position indicated on the lower right side of the screen (at 20º in the upper figure).
Every time the spindle orientation key is pressed, the spindle position increments in that value (20º
in the upper figure).
When the machine does not use spindle gears, this message makes no sense. That is why the CNC
does not show this message when text 28 of program 999997 has not been defined.
To Next Page
Loading...
