CNC 8055
CNC 8055i
·TC· OPTION
SOFT: V02.2X
3
·75·
WORKING WITH OPERATIONS OR
CYCLES
Use the following CNC keys to select the different machining operations or cycles.
User cycles
The user cycle is edited like any other standard cycle of the TC mode. Once all the required data
has been defined, the user can simulate or execute the cycle like any other standard cycle of the
TC mode.
Cycles or operations of the CNC
When pressing any other key, the CNC selects the corresponding standard machining cycle,
changes the display and turns on the lamp of the key that has been pressed (indicating the selected
type.
Standard machining operations or cycles may be selected with each one of the following keys:
It is possible to combine ISO-coded blocks with standard and/or user cycles to create part-programs.
Chapter "6 Saving programs"describes in detail how to do it and how to use those programs.
To de-select a cycle and return to the standard screen, press the key for the selected cycle (the one
with the lamp on) or the [ESC] key.
When pressing [PCALL], the CNC shows all the user cycles defined by the machine
manufacturer with the WGDRAW application.
Positioning cycle. Threading cycle.
Turning cycle. Grooving cycle.
Facing cycle. Drilling and tapping cycle.
Taper turning cycle. Profiling cycle.
Rounding cycle.
When the machining operation or cycle has several levels, [LEVEL CYCLE] must be
pressed to select the desired cycle level.
To Next Page
Loading...
