Feig Electronic OBID i-scan ID ISC.PR101 User Manual

OBID i-scan
®
System-Manual ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH Page 103 of 131 H60301-3e-ID-B.doc
• * If a MB89R118 Transponder is detected in reader field, the corresponding Fast Custom
Specific Commands can be used by the Reader. This depends on the settings of the Cus-
tomer Command Option Bytes (see: 3.10. CFG16: Customer Command Option Bytes ).
In details:
Used Command Executed Fast Command, if enabled
[0x23] Read Multiple Blocks (max. 2 Blocks) [0xC3] Fast Read Multiple Blocks (max. 2 Blocks)
[0x24] Write Multiple Blocks (max. 2 Blocks) [0xC4] Fast Write Multiple Blocks (max. 2 Blocks)
[0xA1] Write EAS [0xD1] Fast Write EAS
[0xA5] Read Multiple Blocks Unlimited [0xD5] Fast Read Multiple Blocks Unlimited
Command Number of Blocks Single CMD Multiple CMD
(max. 2 Blocks)
Multiple Unlimited
CMD
N = 1 -
√
-
N = 2 -
√
-
Read
N > 2 - -
√
N = 1 -
√
-
N = 2 -
√
-
Write
N > 2 -
√
-
N = 1
√
--
N = 2
√
--
Lock
N > 2
√
--
Used Commands depends on the number of blocks
** The WR-OPTION will be set automatically by the FEIG Readers if the RW-OPTION parameter
in “3.5. CFG4: Transponder Parameters” is set to “00: automatically set”. Up to two blocks
of data can be written for one request.

Feig Electronic OBID i-scan ID ISC.PR101 Specifications

General

Brand	Feig Electronic
Model	OBID i-scan ID ISC.PR101
Category	Other
Language	English