Feig Electronic OBID i-scan ID ISC.PR101 User Manual

OBID i-scan
®
System-Manual ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH Page 84 of 131 H60301-3e-ID-B.doc
8.2. KSW Custom Commands
These commands supports the functions of the KSW TempSens and VarioSense transponder
8.2.1. [0xA0] Set Passive
This command deactivates the RC-oscillator of the transponder. The temperature detection will be
switched off.
REQUEST-DATA
5 6 (7-14)
0xA0 MODE UID
RESPONSE-DATA (STATUS = 0x95)
5
ISO-ERROR
MODE:
Bit: 7 6 5 4 3 2 1 0
Function - - - - - ADR
ADR:
ADR
b000 non-addressed
b001 addressed
b010 selected
UID:
Read-only serial no. of the transponder. The UID is required only in the addressed mode.
ISO-ERROR:
ISO error code of transponder response. This byte is only available if STATUS = 0x95.

Feig Electronic OBID i-scan ID ISC.PR101 Specifications

General

Brand	Feig Electronic
Model	OBID i-scan ID ISC.PR101
Category	Other
Language	English