Feig Electronic OBID i-scan ID ISC.PR101 User Manual

OBID i-scan
®
System-Manual ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH Page 57 of 131 H60301-3e-ID-B.doc
6. Protocols for ISO15693 Host Commands
Some ISO15693Host commands can be used to access I-Code 1 Transponders. The additional com-
mands Read Config Block and Write Config Block were created by FEIG ELECTRONIC to provide
full Transponder configuration capabilities for I-Code 1 Transponders via the OBID
®
i-scan memory
model (see ANNEX G: Memory Model I-Code 1 Transponders). The following combinations are possi-
ble:
Transponder Types
I-Code 1 ISO15693 I-Code
EPC/UID
6.1. [0xB0] Host commands for ISO15693 Mandatory
and Optional Commands
√√ √
6.1.1. [0x01] Inventory
√√ √
6.1.2. [0x02] Stay Quiet
√
6.1.3. [0x22] Lock Multiple Blocks
√
√
1
6.1.4. [0x23] Read Multiple Blocks
√√
6.1.5. [0x24] Write Multiple Blocks
√√ √
6.1.6. [0x25] Select
√
6.1.7. [0x26] Reset to Ready
√
6.1.8. [0x27] Write AFI
√
6.1.9. [0x28] Lock AFI
√
6.1.10. [0x29] Write DSFI
√
6.1.11. [0x2A] Lock DSFI
√
6.1.12. [0x2B] Get System Information
√
6.1.13. [0x2C] Get Multiple Block Security Status
√
6.1.14. [0xA0] Read Config Block
√
2
6.1.15. [0xA1] Write Config Block
√
3
8. [0xB1] Host commands for ISO15693 Custom and
Proprietary Commands
√
8.6. [0xBF] ISO15693 Transparent Command
√
1
only Philips I-Code UID
2 3
Read and Write Config Block will only be available if the I-CODE_MODE (MAPPING)is set to “FEIG Memory
Model“ see: 3.5. CFG4: Transponder Parameters

Feig Electronic OBID i-scan ID ISC.PR101 Specifications

General

Brand	Feig Electronic
Model	OBID i-scan ID ISC.PR101
Category	Other
Language	English