Feig Electronic OBID i-scan ID ISC.PR101 User Manual

OBID i-scan
®
System-Manual ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH Page 92 of 131 H60301-3e-ID-B.doc
8.3.4. [0xA5] EAS Alarm
If the EAS bit is set to 1 the EAS response status 0x00 is returned from the transponder. This com-
mand is available in all modes (non-addressed , addressed and selected).Whether the reader receives
the sequence or not is shown to the host by setting the status byte.
REQUEST-DATA
5 6 (7-14)
0xA5 MODE UID
RESPONSE-DATA (STATUS = {0x95})
5
ISO-ERROR
MODE:
Bit: 7 6 5 4 3 2 1 0
Function - - - - - ADR
ADR:
ADR
b000 non-addressed
b001 addressed
b010 selected
UID:
Read-only serial number of the transponder. The UID is required only in the addressed mode.
ISO-ERROR:
ISO error code of transponder response. This byte is only available if STATUS = {0x95}.
Note:
• If an error is detected or the EAS bit is set to “0” the transponder remains silent and the
status 0x01 will be sent to the host.
• If EAS bit is set to “1” the status will be 0x00.

Feig Electronic OBID i-scan ID ISC.PR101 Specifications

General

Brand	Feig Electronic
Model	OBID i-scan ID ISC.PR101
Category	Other
Language	English