Feig Electronic OBID i-scan ID ISC.PR101 User Manual

OBID i-scan
®
System-Manual ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH Page 121 of 131 H60301-3e-ID-B.doc
ANNEX D: Index of Status Bytes
Hex-value
General
0x00
OK:
• Data / parameters have been read or stored without error
• Control command has been executed
Hex-value
Transponder Status
0x01
No Transponder:
• No Transponder is located within the detection range of the Reader.
• The Transponder in the detection range has been switched to mute.
• The communication between Reader and Transponder has been interfered and the Reader
is not able to read the Transponder anymore.
0x02
Data False:
• CRC16 data error on received data.
0x03
Write-Error:
Negative plausibility check of the written data:
• Attempt to write on a read-only storing-area.
• Too much distance between Transponder and Reader antenna.
• Attempt to write in a noise area.
0x04
Address-Error:
The required data are outside of the logical or physical Transponder-address area:
• The address is beyond the max. address space of the Transponder.
• The address is beyond the configured address space of the Transponder.
0x05
Wrong Transponder-type:
This command is not applicable at the Transponder:
• Attempt to write on or read from a Transponder.
• A special command is not applicable to the Transponder.

Feig Electronic OBID i-scan ID ISC.PR101 Specifications

General

Brand	Feig Electronic
Model	OBID i-scan ID ISC.PR101
Category	Other
Language	English