EasyManuals Logo

Festo CPX-CMAX-C1-1 User Manual

Festo CPX-CMAX-C1-1
446 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #112 background imageLoading...
Page #112 background image
3. Drive functions
3−50
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
3.2.7 Teaching
The following values can be taught:
Setpoint values in the record list (record selection)
Project zero point and software end positions (commis
sioning).
Setpoint value sequence in the record list
Position or force values can be taught. The existing setpoint
values are overwritten here. The type is determined by the
control mode in record
control byte 1 (RCB1).
1. Set record select mode
(OPM2 = 0 + OPM1 = 0).
The record number (PLC output data, byte 3) must be
set on the record which is to be taught. It is trans
ferred to CPOS.TEACH with a positive edge.
If a force value is to be taught, the
control mode must
be set to force" in record control byte 1 (RCB1).
2. Via jog mode, the drive is put into the desired position by
positioning or manually (by moving by hand in Drive
disabled" state).
3. Teaching is done via the bit handshake in the control and
status bytes CPOS/SPOS (Fig.3/9).

Table of Contents

Other manuals for Festo CPX-CMAX-C1-1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Festo CPX-CMAX-C1-1 and is the answer not in the manual?

Festo CPX-CMAX-C1-1 Specifications

General IconGeneral
BrandFesto
ModelCPX-CMAX-C1-1
CategoryController
LanguageEnglish

Related product manuals