Festo CPX-CMAX-C1-1 User Manual

6. Parametrisation
6−6
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
6.1.2 Special features of the system of measurement
The following special rules apply to accessing the system of
measurement. For detailed information on the system of
measurement, see section B.1:
 The system of measurement cannot be switched over at
will. To change the system of measurement, the axis data
must be reset.
 After defining the system of measurement (metric / im
perial),
the cylinder type must be transmitted. This de
fines the movement type translatorily / rotatorily.
 Only when the system of measurement has been defined,
can PNUs be accessed that are larger than PNU 300 (ex
ceptions: PNU 1100, 1190).

Festo CPX-CMAX-C1-1 Specifications

General

Brand	Festo
Model	CPX-CMAX-C1-1
Category	Controller
Language	English