6. Parametrisation
6−5
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Error Error
escr
pt
on
0 Impermissible PNU.
1 Parameter value cannot be chan ged.
2 Lower or upper value limit exceeded.
3 Inv alid subin dex.
11 No hig her−order controller . FCT must acce p t device con trol in order to write this parameter.
This error can only be generated via the service interface.
12 The password entered is wrong.
17 Request cannot be carried out due to operating status. Please check operatin g mode, stop
and enable signal s.
101 Request ID is not supported.
102 Parameter cannot be read (password).
103 The system of measurement has not been config ured yet. Access to the parameter is not
possible.
104 The cylinder type has not been config ured yet. Access to the parameter is not possible.
105 The system of measurement has already been configu red and cannot be changed without a
data reset.
106 Cylin der type cannot be changed since it does not match the system of measuremen t.
107 The value cannot be changed since there is iden ti fi cation data. Please reset the iden tifi cati on
data before writing the value.
108 The parameter value does not match the hardware recognised.
(Note : the cylinder type must match the measurin g system)
109 Serial numbers cannot be changed before the iden tifi cati on data has been reset.
Tab.6/5: Error numbers for parameter transmission
To Next Page
Loading...
Need help?
General
