Festo CPX-CMAX-C1-1 User Manual

A. Notes on commissioning and service
A−17
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
A.2.4 C03: Movement test
After parametrising, a movement test should be executed to
check the drive’s control direction. During this, the system
checks that the tubes are correctly connected. After parame
trising, the CMAX expects the movement test to be executed
and indicates this by issuing C03 on the display.
The movement test must either be executed
or skipped (not
recommended).
Information on executing the movement test can be found in
section 3.2.1.
A.2.5 Homing and identification
After the successful movement test, the following functions
need to be executed:
 Homing, see section 3.2.2
(only with measuring type "encoder").
 Identification, see section 3.2.5

Festo CPX-CMAX-C1-1 Specifications

General

Brand	Festo
Model	CPX-CMAX-C1-1
Category	Controller
Language	English