Festo CPX-CMAX-C1-1 User Manual

5. Parameter
5−94
Festo P.BE−CPX−CMAX−CONTROL−EN en 0908NH
Notes on PNU 1190:
 Behaviour on delivery or after resetting the axis or
device data: The recognized configuration is not auto
matically included in the setpoint configuration. Instead
the setpoint configuration is filled with 0. The setpoint
configuration must be written in a way that is compatible
with the actual configuration.
 Behaviour upon
normal star t: If the recognized hardware
does not correspond with the setpoint configuration, this
will trigger error handling. A decision is made as to
whether the change must lead to a warning or a fault.
Possibly the controller will not be activated.
If an identification is performed successfully, the serial
numbers are adopted
so that the warning Exchanged
hardware" is no longer issued the next time the device is
switched on.
 The piston rod diameter is not provided by the sensor
interface. The actual configuration always contains the
value0. However, since this is a valid value for rodless
drives, the value0 is not consider ed as not recognized"
in the case of the piston rod diameter. Therefore no
SETPOINT−ACTUAL check is performed after switching on.

Festo CPX-CMAX-C1-1 Specifications

General

Brand	Festo
Model	CPX-CMAX-C1-1
Category	Controller
Language	English