Festo CPX-CMAX-C1-1 User Manual

5. Parameter
5−96
Festo P.BE−CPX−CMAX−CONTROL−EN en 0908NH
Commissioning operation
configuration status
PNU PNU: 1192 Index: 2 Max index: 8 Class: Struct Data type: int32
Values Without unit
Default: 0 Minimum: 0 Maximum: 4
When commissioning a certain number of parameters must be transmitted in a certain order. This
parameter provides information about the status of parametrising and about the next commissioning
step to be performed.
Possible return values Display
= 0: Waiting for system of measurement C00
= 1: Waiting for cylinder type C00
= 2: Waiting for axis data C00
= 3: Waiting for movement test C00
= 4: Axis configuration completed depending on respective operating mode
ý The parameter value cannot be changed.
o Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
o After writing, controller recalculation is carried out.

Festo CPX-CMAX-C1-1 Specifications

General

Brand	Festo
Model	CPX-CMAX-C1-1
Category	Controller
Language	English