C. Configuration with CPX node
C−7
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Note
CPX terminals with the CMAX always require new parame
trisation and commissioning after exchanging the CPX ter
minal or the CMAX, since the parameters and the data as
certained during commissioning are only stored in the
CMAX, see section 1.1.2.
The CMAX cannot be parametrised via the start−up parame
trisation. This must always
be done via the FCT or via the
special parametrisation function.
Fig.C/3: No specific parameters
To Next Page
Loading...
Need help?
General
