15 Data logger
FLUXUS F60* 15.3 Configuration of the data logger
139
UMFLUXUS_F60xV5-0EN, 2017-10-16
Totalizer storing
It is possible to store the currently displayed totalizer only or to store one value for each
flow direction.
• Select one to store the currently displayed totalizer value only. This can apply for the
positive and negative totalizer.
• Select both to store the totalizer values for both flow directions.
• Press ENTER.
Signal amplitude storing
•Select
on
to store the amplitude of the measured signal together with the measured values.
• Press ENTER.
Fluid sound speed storing
• Select on to store the fluid sound speed together with the measured values.
• Press ENTER.
Diagnostic values storing
• Select on to store the diagnostic values together with the measured values.
• Press ENTER.
Acoustic signal during the storing
Per default, an acoustic signal will be emitted every time a measured value is stored or
transmitted to a PC or printer.
• Select off to deactivate the acoustic signal, on to activate it.
• Press ENTER.
Special Funct.\SYSTEM settings\Storing\Quantity Storage
Special Funct.\SYSTEM settings\Storing\Store Amplitude
Special Funct.\SYSTEM settings\Storing\Store c-Medium
Special Funct.\SYSTEM settings\Storing\Store diagnostic
Special Funct.\SYSTEM settings\Storing\Beep on storage
To Next Page
Loading...
Need help?
General
