Flexim FLUXUS F60 Series - Page 205

20 Wall thickness measurement (optional)
FLUXUS F60* 20.4 Measurement
205
UMFLUXUS_F60xV5-0EN, 2017-10-16
20.4.6 Storage/transmission of the wall thickness
• Press ENTER to stop the measurement and to store or output the measured value.
The following display appears if a valid wall thickness has been measured and a trans-
mission of measured value is activated:
• Select yes to store and/or output the measured value.
The wall thickness can be transmitted into the current parameter record.
The pipe material will be replaced by the material used for the wall thickness measure-
ment.
If the serial transmission is activated, the measured value will be transmitted.
20.4.7 Stop of the wall thickness measurement
• In order to quit the wall thickness measurement mode, disconnect the wall thickness
measurement from the transmitter.
Transfer Data
no >YES<