7 Connection
FLUXUS F60* 7.2 FLUXUS *608
65
UMFLUXUS_F60xV5-0EN, 2017-10-16
Maintenance (relearn cycle)
The accuracy of the displayed value for the charge state of the battery is improved by ex-
ecuting a relearn cycle. The ambient temperature during a relearn cycle should be in the
range of 12...30 °C.
• Select Special Funct.\Battery status.
• Press ENTER.
The charge state of the battery is displayed (here: 73 %).
A question mark (?) and RELEARN indicate that the value for the displayed battery charge
is not reliable. A relearn cycle is recommended.
Proceed as follows for a relearn cycle:
• Charge the battery completely. The LED "BATTERY" lights green when charging is fin-
ished.
• Discharge the battery completely: Remove the power supply unit from the transmitter.
In order to deactivate the automatic power-off during discharging, start a measurement.
Discharging takes min. 14 h. The LED "BATTERY" will flash red afterwards.
Automatic power-off
In battery mode, the transmitter has an automatic power-off. The transmitter will be
switched off if
• no measurement is being made and no key is pressed within 10 min or
• the battery is empty
This message will be displayed before the transmitter is switched off automatically. A
countdown with an acoustic signal will be started.
The countdown can be stopped by pressing any key.
If this message is displayed when the transmitter is switched on, the transmitter has been
switched off automatically due to a too low battery charge.
Special Funct.\Battery status
To Next Page
Loading...
Need help?
General
