Operating NetDAQ Logger for Windows
Starting and Stopping Logging
4
4-5
Clearing an Instrument’s Totalizer Value 4-5.
If you check Logging | Clear Totalizer on Start, NetDAQ Logger will clear the
totalizer count in each instrument when you start logging for that instrument.
Otherwise, the totalizer value in the instrument will not be cleared.
Simulated Logging 4-6.
If you check Logging | Simulate Logging on Start, NetDAQ Logger will simulate
all data collection rather than connecting to the instrument(s). When NetDAQ
Logger is simulating data collection for one or more instruments, their icons will
read “SIM” instead of “LOG.”
ds057s.bmp
Selecting an Instrument’s Scanning Duration 4-7.
Complete the following procedure to select a duration for instrument scanning.
NetDAQ Logger will automatically stop logging for the instrument after the
specified interval of time has elapsed since the start of logging.
1. Highlight the desired instrument icon.
2. Select Setup | Instrument Config to open the Instrument Configuration dialog
box (below).
To Next Page
Loading...
Need help?
General
