Preparing for Operation
Host Computer and Network Preparation
2
2-53
6. Check the setup. If the setup is correct, click Next to begin file transfer.
If you want to change the setup, click Back to go to the appropriate screen and
make the changes. Click Next and check the setup again. If it is correct, click
Next to begin file transfer.
Installing NetDAQ Logger with Trumpet 2-46.
To install 16-bit NetDAQ Logger and Trumpet, complete the following procedure:
1. Insert NetDAQ Logger Disk 1 and run the setup application (setup.exe). Click
Next in the first dialog box.
2. Select Isolated with Trumpet TCP/IP Stack and Winsock Network Type. Click
Next.
3. Select the desired destination directory. On 16-bit systems, the default is
c:\netdaq. Setup and data file storage defaults to the same directory. Use
Browse if you want to change the directory.
4. Select the language of the user interface: English, French, German, or
Spanish. Click Next.
5. Select the Ethernet adapter you are using.
Modify the four fields if necessary (see Appendix I for discussion of packet
drivers and the other fields).
ds307s.bmp
To Next Page
Loading...
Need help?
General
