3.4 Programming Mode
3-20
Listed below are the function codes (including those not subject to quick setup) available on the
FRENIC-MEGA. A function code is displayed on the LED monitor on the keypad in the following format:
Figure 3.4-2
Table 3.4-3 Function Codes Available on FRENIC-MEGA
Function Code Group Function
Codes
Function Description
F codes
(Fundamental functions)
F00 to F80 Fundamental
functions
Functions concerning basic
motor running
E codes
(Extension terminal
functions)
E01 to E99 Extension terminal
functions
Functions concerning the
assignment of control circuit
terminals
Functions concerning the display
of the LED monitor
C codes
(Control functions
of frequency)
C01 to C53 Control functions Functions associated with
frequency settings
P codes
(Motor 1 parameters)
P01 to P99 Motor 1 parameters Functions for setting up
characteristics parameters (such
as capacity) of the motor
H codes
(High performance
functions)
H03 to H98 High performance
functions
Highly added-value functions and
functions for sophisticated control
A codes
(Motor 2 parameters)
A01 to A56 Motor 2 parameters Functions for setting up
characteristics parameters (such
as capacity) of the motor
b codes
(Motor 3 parameters)
b01 to b56 Motor 3 parameters Functions for setting up
characteristics parameters (such
as capacity) of the motor
r codes
(Motor 4 parameters)
r01 to r56 Motor 4 parameters Functions for setting up
characteristics parameters (such
as capacity) of the motor
J codes
(Application functions 1)
J01 to J96 Application functions 1 Functions for applications such
as PID control
d codes
(Application functions 2)
d01 to d63 Application functions 2 Functions for applications such
as speed control
U codes
(Application functions 3)
U00 to U91 Application functions 3 Functions for applications such
as customizable logic
y codes
(Link functions)
y01 to y99 Link functions Functions for controlling
communication
o codes
(Option functions)
o27 to o59 Option functions Functions for options (Note)
(Note) The o codes are displayed only when the corresponding option is mounted.
For details of the o codes, refer to the Instruction Manual for the corresponding option.
For the list of function codes subject to quick setup and their descriptions, refer to Chapter 5
"FUNCTION CODES."
Function code group
ID number in each function
To Next Page
Loading...
