Fuji Electric Frenic Mega Series - Page 731

App. G Replacement Information
A-35
App.
FRENIC5000G11S/P11S FRENIC-MEGA
Class
Terminal Signal Name Terminal Signal Name
(IL) Interlock IL Interlock
(Hz/TRQ) Cancel torque control -
(LE) Link operation selection LE Link operation selection
(U-DI) Universal DI U-DI Universal DI
(STM)
Start characteristics
selection
STM
Start characteristics
selection
(STOP1) Force to stop STOP Force to stop
(STOP2) Force to stop
(PG/Hz) SY-PG enable -
(ZERO)
Zero speed command with
PG option
-
(EXITE) Pre-excitation EXITE Pre-excitation
(Hz/LSC)
Cancel constant peripheral
speed control
-
Digital input
(LSC-HID)
Line speed frequency
memory
-
FMA Analog monitor FMA Analog monitor Analog
output
(11) (Analog common) (11) (Analog common)
FMP
Pulse rate monitor
(Pulse waveform output)
FMP Pulse monitor
Pulse
output
(CM) (Digital common) (CM) (Digital common)
Y1 Transistor output 1 Y1 Transistor output 1
Y2 Transistor output 2 Y2 Transistor output 2
Y3 Transistor output 3 Y3 Transistor output 3
Y4 Transistor output 4 Y4 Transistor output 4
CME Transistor output common CMY
Transistor output
common
(RUN) Running RUN Running
(FAR)
Frequency (speed) arrival
signal
FAR
Frequency (speed) arrival
signal
(FDT)
Frequency (speed)
detected
FDT
Frequency (speed)
detected
(FDT2)
Frequency (speed)
detected 2
FDT2
Frequency (speed)
detected 2
(LU) Undervoltage detected LU Undervoltage detected
(B/D) Torque polarity detected B/D Torque polarity detected
(TL) Torque limiting IOL Inverter output limiting
(IPF)
Auto-restarting after
momentary power failure
IPF
Auto-restarting after
momentary power failure
(OL)
Motor overload early
warning
OL
Motor overload early
warning
(OL2)
Motor overload early
warning 2
-
(KP) Keypad operation enabled KP
Keypad operation
enabled
(STP) Inverter stopped RUN
Inverter running (negative
logic setting)
(RDY) Inverter ready to run RDY Inverter ready to run
(SW88)
Switch between
commercial power/inverter
operation
SW88
Switch between
commercial
power/inverter operation
(SW52-2)
Switch between
commercial power/inverter
operation
SW52-2
Switch between
commercial
power/inverter operation
(SW52-1)
Switch between
commercial power/inverter
operation
SW52-1
Switch between
commercial
power/inverter operation
(SWM2) Motor 2 selected SWM2 Motor 2 selected
Transistor output
(AX) AX terminal function AX AX terminal function