Output Format
167
Copy
3
Bond, Plain, Recycled, Plain Reload, Lightweight, Heavyweight, Heavyweight Reload,
Extra Heavyweight, Extra Heavyweight Reload, Extra Heavyweight Plus, Extra
Heavyweight Plus Reload, Punched, Gloss, Gloss Reload, Heavyweight Gloss,
Heavyweight Gloss Reload, Extra Heavyweight Gloss, Extra Heavyweight Gloss Reload,
and Custom Paper 1 to 5.
z
Finisher B1
Bond, Plain, Recycled, Plain Reload, Lightweight, Heavyweight, Heavyweight Reload,
Extra Heavyweight, Extra Heavyweight Reload, Punched, Gloss, Gloss Reload,
Heavyweight Gloss, Heavyweight Gloss Reload, and Custom Paper 1 to 5.
z
Booklet Maker Unit for Finisher B1
Bond, Plain, Recycled, Plain Reload, Heavyweight, Extra Heavyweight, and Custom Paper
1 to 5.
z
C3 Finisher
Bond, Plain, Recycled, Plain Reload, Lightweight, Heavyweight, Heavyweight Reload,
Extra Heavyweight, Extra Heavyweight Reload, Extra Heavyweight Plus, Extra
Heavyweight Plus Reload, Punched, Gloss, Gloss Reload, Heavyweight Gloss,
Heavyweight Gloss Reload, Extra Heavyweight Gloss, Extra Heavyweight Gloss Reload
and Custom Paper 1 to 5.
z
C3 Finisher with Booklet Maker
Bond, Plain, Recycled, Plain Reload, Heavyweight, Extra Heavyweight, and Custom Paper
1 to 5.
z
Ensure that the actual orientation of the original document matches the [Original Orientation] setting on the
[Layout Adjustment] screen.
z
In the following cases, the actual stapling position differs from the stapling position displayed on the screen:
z
When [Original Orientation] is set to [Upright Images], and [Staple] is set to one position at the right side.
z
When [Original Orientation] is set to [Sideways Images], and [Staple] is set to one position at the left side.
îš„ Hole Punch
Sets the position for punching.
The positions for punching vary depending on a finisher installed.
The C3 Finisher and C3 Finisher with Booklet Maker offer nine different punch positions: 2
Holes, 2 Holes Top, 2 Holes Right, 3 Holes, 3Holes Top, 3Holes Right, 4 Holes, 4 Holes Top, 4
Holes Right.
z
Ensure that the actual orientation of the original document matches the [Original Orientation] setting on the
[Layout Adjustment] screen.
îš„ Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
z
If the [Original Orientation] setting differs from the actual document orientation, the machine may not
detect the top of the document correctly.
îš‹ Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
To Next Page
Loading...
Need help?
General
