Fax
240
Fax
4
2 Select [Auto] or [Fax <Line N>] from the popup menu.
z
When [Fax <Line N>] is selected, a fax job is transmitted to all specified recipients using the selected line.
z
When selecting [IP Fax (SIP)] as the address type, [Line Selection] is selectable, however, the setting is invalid
and a fax job cannot be transmitted using the selected line.
z
You can set a line name as you intended. The line name can be set within 13 single-byte characters. For more
information, refer to "Tools" > "Fax Service Settings" > "Screen Defaults" > "Fax Screen Default" in the
Administrator Guide.
Entering Specific Symbols
When specifying a recipient, you can use the following features to enter specific symbols on
the touch screen.
z
When using the DTMF method, use specific symbols. For information on the DTMF method, refer to "Remote Folder (Using Remote
Folder)" (P.267) and "Broadcast" (P.285).
Removing/Confirming a Recipient
You can remove or confirm recipients from the pop-up menu.
Feature Button Function Input method
Enter pause
- or <Pause> (-)
Used to enter a pause.
One pause is 3 seconds.
You can enter pauses of 6
seconds, 9 seconds, etc. with
additional button presses.
Press the <Pause> button.
(Example)
0-123 ...
0--123 ...
Transmit using
a password
S When a password has been set,
transmission will start only if
the password matches the ID
number on the remote
terminal.
1. Select the keyboard
button on the [Fax/
Internet Fax] screen to
display the keyboard.
2. Select [S].
(Example)
0312345678S12345678
Transmit DTMF
signal
! Used to transmit the DTMF
signal.
1. Select the keyboard
button on the [Fax/
Internet Fax] screen to
display the keyboard.
2. Select [More
Characters].
3. Select [!].
(Example)
0311123456!123#
To Next Page
Loading...
Need help?
General
