Copying Procedure
85
Copy
3
Step 3 Entering a Quantity
You can enter up to 999 sets.
1 Enter the number of copies using the numeric keypad.
The number of copies entered appears on the upper right of the touch screen.
2 If you have entered an incorrect value, press the <C (Clear)> button and then enter the
correct value.
Step 4 Starting the Copy Job
1 Press the <Start> button.
z
If the document has been loaded in the document feeder, do not hold down the document while it is being
conveyed.
z
Copies cannot be made if a copy protection code is detected. For information on copy protection codes, refer
to "Secure Watermark (Managing Document Security)" (P.160).
z
If a problem occurs, an error message appears on the touch screen. Follow the instructions of the message to
solve the problem.
z
You can set the next job during copying.
If you have more documents
If you have more documents to copy, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to scan the documents as a single set of
data.
2 Select [Next Original] while scanning is in progress.
z
When using the document feeder, load the next document after the machine has finished scanning the first
document.
z
When [Next Original] is displayed on the screen and no operation is performed for a certain period of time,
the machine automatically assumes that there are no more documents.
z
You can change the number of copies by selecting [Change Quantity] that is displayed after selecting
[Delete].
To Next Page
Loading...
