Fax
258
Fax
4
Priority Send/Delay Start (Specifying Send Priority/Send Time)
The Priority Send feature allows you to give priority to a fax or polling job over other jobs.
The Delay Start feature allows you to specify when to send your fax. This feature is useful
for sending faxes when communication charges are low, such as during night time.
z
[Priority Send/Delay Start] is not available for Internet Fax.
z
The Priority Send feature is not available for Server Fax.
z
For Server Fax, [Delay Start] is available when the FTP or SMB protocol is used, but not when the SMTP
protocol is used.
z
When [Delay Start] is set for Server Fax, this setting applies to transmission from the Server Fax server to a
final destination, but not from the machine to the Server Fax server.
z
[Priority Send] can be set in combination with [Delay Start]. If both features are set, Priority Send is performed
at the time specified in [Delay Start].
1 Select [Priority Send/Delay Start].
2 Select any option.
îš„ Priority Send
îš‹ Off
Priority Send is not applied.
îš‹ On
Priority Send is applied.
z
If the Priority Send feature is selected during transmission, the fax will be sent after the current transmission
ends.
z
In redial mode, the fax will be resent preferentially after the specified redial interval.
z
The Priority Send feature cannot be set separately for each recipient of Broadcast and multi-polling jobs.
z
You can give priority to a pending job. For more information, refer to "Job Status" (P.479).
To Next Page
Loading...
Need help?
General
