Power Saver Mode
57
Product Overview
2
z
Selecting [Apply] in CentreWare Internet Services
z
Setting a document in the document feeder
z
Opening the document cover
z
Detecting human presence by the Smart WelcomEyes of the machine
z
Opening the front cover
z
When the machine is in the Sleep mode, it takes longer time to exit the Power Saver mode than when the
machine is in the Low Power mode.
When the following device is connected to the machine and a user performs the following
operation, the Low Power mode can be deactivated without pressing the <Power Saver>
button.
z
Touching the IC Card Reader (optional) with a card
z
The Sleep mode cannot be deactivated by the operation. When the above device is connected to the
machine, you can make the machine exi
t the Power Saver mode without pressing the <Power Saver> bu
tton
by setting longer time to elapse until the machine enters the Sleep mode.
z
When the machine enters the Sleep mode with the IC Card Reader (optional) connected, it may take longer
time to exit the Power Saver mode.
Making devices necessary to activate the machine exit the Power Saver mode
The machine is equipped with the feature to save electricity by supplying power only to the
devices necessary to activate the machine when the machine exits the Power Saver mode.
When the <Power Saver> button is pressed, the touch screen is lit on, but the document
feeder and the output devices do not exit the Power Saver mode. Afterwards, by selecting a
service on the touch screen, the machine supplies power only to the devices necessary to
activate the service.
z
When the machine receives jobs such as print and print fax, the touch screen is not lit on and only the output
devices exit the Power Saver mode and start to print.
z
When the machine receives jobs such as stored print (Secure print, Delayed print, Charge print, and Private
charge print), direct fax, and fax using folder receive, and when you access a folder of the machine using
CentreWare Internet Services, the touch screen is not lit on and only the hard disk exits the Power Saver
mode.
The machine cannot load papers and replace consumables appropriately when the
machine is in the Power Saver mode. Press the <Power Saver> button and then <Machine
Status> button to load papers and replace consumables.
Smart WelcomEyes
The machine provides human detection feature called Smart WelcomEyes. When Smart
WelcomEyes detects human presence within the range of approximately 35 cm from the
machine front, it operates as follows:
z
Deactivation of the Power Saver mode without pressing the <Power Saver> button
When the sensor detects human presence, the Power Saver mode is released and then
exited.
z
Prohibition of entering the Power Saver mode
While the sensor is detecting human presence, the machine does not enter the Power
Saver mode.
z
Deactivation of timer control
To Next Page
Loading...
Need help?
General
