Layout Adjustment
399
Scan
5
îš„ Binding Edge Erase
Erases the shadow from the center section of the document. You can specify the binding
erase width in the range from 0 to 50 mm in 1 mm increments.
Original Size (Specifying a Scan Size)
This feature allows you to set the scan size for a document.
Use this feature when a document is a non-standard size, or when you want to scan a
document at a size different from the original size. You can also add margins, or delete
unnecessary margins using this feature.
1 Select [Original Size].
2 Select any option.
When you select a non-standard size, specify values for the X and Y directions.
îš„ Auto Detect
Detects the document size automatically. The following table shows the document sizes
that can be detected automatically.
* : Detectable only when the Duplex Automatic Document Feeder C1-PC is installed.
z
If the document size cannot be detected automatically, a screen to enter the document size appears.
z
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System Administration
mode. For information on [Paper Size Settings], refer to "Tools" > "Common Service Settings" > "Other Settings" > "Paper Size
Settings" in the Administrator Guide.
Document feeder Document glass
Auto-detectable
Document Sizes
B6
*
, B5, B5 , B4, A6
*
, A5, A5 , A4,
A4 , A3, 8.5 x 11", 8.5 x 11" , 11 x
17", 16K , 8K
B6, B6
*
, B5, B5 , B4, A6,
A5, A5 , A4, A4 , A3, 8.5 x
11" , 11 x 17"
To Next Page
Loading...
Need help?
General
