Scanning Procedure
305
Scan
5
Document Glass
The document glass supports a single sheet, a book, or other similar documents with sizes
from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
z
Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard size
documents, enter the size on the [Original Size] screen.
z
For information on document sizes that can be detected automatically and how to enter a non-standard document size, refer to
"Original Size (Specifying a Scan Size)" (P.399).
z
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on the paper size settings, refer to "Tools" > "Common Service
Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
1 Open the document cover.
z
Ensure that the touch screen is active, and then load a document. Otherwise, the machine may not properly
detect the document size.
2 Load the document face down, and align it against the top left corner of the document
glass.
3 Close the document cover.
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
To Next Page
Loading...
