Copying Procedure
83
Copy
3
Document Glass
The document glass supports a single sheet, a book, or other similar documents with sizes
from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
z
Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard size
documents, enter the size on the [Original Size] screen.
z
For information on document sizes that can be detected automatically and how to enter a non-standard document size, refer to
"Original Size (Specifying the Scan Size for the Document)" (P.127).
z
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on the paper size settings, refer to "Tools" > "Common Service
Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
1 Open the document cover.
z
Make sure that the touch screen is active, and then load a document. Otherwise, the machine may not
properly detect the document size.
2 Load the document face down, and align it against the top left corner of the document
glass.
3 Close the document cover.
z
When a standard size document is loaded on the document glass, the size of the document is displayed in the
message field.
Do not apply excessive force to hold thick document on the document glass. It
may break the glass and cause injuries.
To Next Page
Loading...
Need help?
General
