How to prevent paper curling in Fuji Xerox Document Centre 286?
To prevent paper curling in your Fuji Xerox All in One Printer: * Check that the paper is loaded correctly. Load paper in Trays 1, 2, 3 and 4 seam side up. * Load paper in the Tandem Tray Module and bypass tray seam side down. * Load custom media in the bypass tray.
How to remove streaks from Fuji Xerox All in One Printer output?
To remove streaks, solid or dotted lines, or spots from your Fuji Xerox All in One Printer output: * Clean the document glass, the CVT glass, the areas under the platen cover, the document feeder, and the paper guides. * If the machine has been idle for an extended period of time, or if the toner or drum cartridge is new, begin the job again. * Run the job using the document glass. * Reinstall the drum cartridge. * Check the quality of the document. Use [Border Erase] to remove lines and marks from the edges of the document. * Load fresh paper. * Check the humidity of the machine location.
How to adjust the darkness of the print on Fuji Xerox Document Centre 286?
If the output from your Fuji Xerox All in One Printer is too light or too dark: * Load fresh paper. * Check the quality of the document. * Select [Lighten/Darken] on the touch screen. * Run off more prints until the copy quality improves. * Replace the drum cartridge.
Why Fuji Xerox Document Centre 286 All in One Printer does not accept documents into memory?
If your Fuji Xerox All in One Printer does not accept documents into memory: * Check with the System Administrator about available memory. * If the memory is almost full, print and delete unnecessary files.
What to do if Fuji Xerox All in One Printer displays a memory full error message?
If your Fuji Xerox All in One Printer displays a memory full error message: * Check with the System Administrator about available memory. * Divide the remaining pages of the job into several small jobs and run the job again.
How to fix Fuji Xerox Document Centre 286 that will not power on?
If your Fuji Xerox All in One Printer won't power on, try these steps: * Check the power cord. * Ensure the power switch is in the ON position. * Verify the RESET button on the back of the machine is not tripped (popped up); push it to reset. * Confirm the AC outlet is supplying voltage by connecting another appliance.
General| Brand | Fuji Xerox |
|---|---|
| Model | Document Centre 286 series |
| Category | All in One Printer |
| Language | English |
Important safety instructions for operating the Fuji Xerox equipment safely.
Description of machine features and available services via the <All Services> screen.
Procedure for powering the machine on and off, including safety information.
Basic steps for making copies, including loading documents and starting the job.
Description of basic features for a copy job on the [Basic Copying] screen.
Basic procedure for sending faxes and iFaxes, including loading documents.
How to specify destinations using features like Address Book and Speed Dial.
Basic scanning procedures including loading documents and saving data.
Scanning documents to send as e-mail attachments.
Basic procedure for using a Job Flow created on a network computer.
Steps to select and execute a job number for stored operations.
Procedure for changing machine defaults and configuring settings.
Changing default settings for network configuration.
Restrictions for job flow sheets and mailboxes when Authentication is enabled.
Step-by-step guide for removing and inserting the drum cartridge.
Step-by-step guide for removing and inserting the toner cartridge.
Ways to identify fault types and apply appropriate solutions.
To Next Page