Fujitsu ETERNUS CS800 - Page 307

1. Click Add.
The Add Trap Destination page displays (see "Add Trap Destination Page" on page
307).
Figure 196: Add Trap Destination Page
2. Enter information about the destination:
IP
Address
Enter the IP address of the system that will receive the traps generated by
the ETERNUS CS800.
Additional Information
l When entering IP addresses, never use an address that is in a reserved
IP address range. To see a list of reserved IP address ranges, click the
quick tip icon [?] located near the IP address field.
l To use hostname format, you must specify at least one DNS IP address
on the Network page (see "Network" on page 319).
Name Enter the name of the destination.
3. Select one or more traps to send to the destination:
Failure Sends failure traps.
ETERNUS CS800 307
10 Configuration