Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
117
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Item Description Parameter/Value Factory Default
Count
(page 122)
Check the counters to determine when to replace
the consumables and to perform cleaning.
Also use it to reset the counter when you have
replaced the consumables or performed
cleaning.
Total Count(ADF)/After cleaning/Brake Roller/Pick Roller 0
Power saving
(page 139)
Specify the waiting time before the scanner
enters power saving mode.
Range: 5 to 235 min. (in increments of 5) 15 min.
Power off after a certain period of time: Select to
set the scanner to turn the power off
automatically if the scanner is left on for a certain
period of time without being used.
Specify the timeout period for the scanner to be
automatically turned off.
[Power off after a certain period of time] check box Selected
1 Hour/2 Hours/4 Hours/8 Hours
(When the [Power off after a certain period of time] check box
is selected)
4 Hours
Offset Setting
(page 126)
Adjust the position to start a scan or end a scan
on the selected scanning side.
Unit: ADF(front)/ADF(back)
Main/Sub/End of page: -2 to +2 mm
(in increments of 0.5)
Main/Sub/End of
page: 0 mm
Vertical
magnification
Adjustment
(page 126)
Adjust the magnification level in feed direction for
the selected scanning method.
Unit: ADF
Range: -3.1 to 3.1% (in increments of 0.1)
0%
To Next Page
Loading...
