Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
123
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
■Resetting the Sheet Counters
When you have replaced or cleaned a consumable part, reset the
corresponding counter by using the following procedure:
1 If you have replaced a consumable, click the [Clear]
button of the consumable that you replaced. If you
performed cleaning, click the [Clear] button of [After
cleaning].
The counter is reset to 0.
2 Click the [OK] button.
A confirmation message appears.
3 Click the [OK] button.
The settings are saved.
ATTENTION
If you turned off the scanner by unplugging the power cable, or
selected [Disable power switch], the number of scanned sheets
may not be counted in [Total Count].
For details about disabling the power switch, refer to "Method of
Turning the Scanner ON/OFF [Power SW Control]" (page 140).
To Next Page
Loading...
