Fujitsu Fi-7030

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
120
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Intelligent Multifeed Function
(page 137)
When there is a paper of the same size attached
to a designated location on the page, you can
configure the scanner to memorize the location of
the attachment and not detect multifeeds for that
location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check Overlapping
and length] in either the scanner driver or the
multifeed detection setting in "Specifying a
Multifeed Detection Method [Multifeed]" (page
132).
Manual mode/Auto mode 1/Auto mode 2 Manual mode
Select to clear the overlap pattern (length,
location) memorized in Auto mode.
[Clear overlap pattern] check box Not selected
Select to record the multifeed pattern on the
window to check an image that is detected as
multifeed.
[Auto-Memorize MF Pattern (only when MF
images are displayed)] check box
Not selected
Specify whether or not to memorize the multifeed
pattern upon power-off.
Remember/Do not remember Do not remember
Number of paper feeding retries
(page 129)
Configure this setting to change the number of
feeding retries when a pick error occurs.
1 to 12 times 4 times
Cleaning Cycle
(page 124)
Specify the scanner cleaning cycle.
Select whether or not to display the cleaning
instruction message from the scanner driver.
1,000 to 255,000 sheets
(in increments of 1,000)
[Show cleaning instructions] check box
3,000 sheets
Not selected
Life Counter Alarm Setting
(page 125)
Specify the replacement cycle for the
consumables.
Pick Rollers/Brake Rollers:
10,000 to 2,550,000 sheets
(in increments of 10,000)
Pick Rollers:
200,000 sheets
Brake Rollers:
200,000 sheets
Vertical Streak Detection
(page 141)
Select whether to enable or disable vertical
streak detection.
Enable to detect vertical streaks (dirt on the glass
sections) when you perform scanning with the
ADF.
Enable/Disable Disable
Vertical Streak Sensitivity
(page 142)
Specify the sensitivity level to detect vertical
streaks (dirt on the glass sections) when vertical
streak detection is enabled.
Low/Normal/High Normal
Item Description Parameter/Value Factory Default