Fujitsu Fi-7030 User Manual

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
125
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Replacement Cycle of Consumables [Life
Counter Alarm Setting]
The replacement cycle for each consumable can be specified.
The background color of the brake roller/pick roller counter (in
[Device Setting]) changes to light yellow when the page count
after a consumable replacement reaches 95% of the value
specified here, and turns yellow when the page count reaches
100%.
A message for replacing a consumable (page 124) also
appears.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 108).
2 From the listing on the left, select [Device Setting 2] 
[Life Counter Alarm Setting].
3 Specify a value as the replacement cycle for each of the
consumables (brake roller and pick roller).
The value can range from 10,000 to 2,550,000 sheets (in increments
of 10,000).

Fujitsu Fi-7030 Specifications

General

Optical Resolution	600 dpi
ADF Capacity	50 sheets
Interface	USB 2.0
Duplex Scanning	Yes
Scanner Type	ADF (Automatic Document Feeder)
Supported Paper Size	A4, A5, A6, B5, B6, Letter, Legal
Scanning Method	Color
Scan Speed (Color, A4, 200 dpi)	30 ppm / 60 ipm
Power Consumption	Operating: 18 W or less
Scanning Speed	30 ppm / 60 ipm
Daily Duty Cycle	Up to 4, 000 sheets