Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
132
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Specifying a Multifeed Detection Method
[Multifeed]
Multifeed is an error where two or more sheets are fed through
the ADF at once. When a different document length is
detected, this detected result is also called a multifeed.
Not noticing multifeed errors while scanning may put you in a
situation where important data are missing from the scanned
images.
Multifeed detection can be used to prevent such troubles.
When this function is enabled, an error message is displayed
as soon as it detects a multifeed, and stops the scan. Note
that multifeed cannot be detected within 30 mm from the
leading edge of the document.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 108).
2 From the listing on the left, select [Device Setting 2]
[Multifeed].
3 Select a detection method.
8.6 Settings Related to Multifeed Detection
Method Description
None Does not detect multifeed.
To Next Page
Loading...
