Fujitsu Fi-7030

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
119
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Item Description Parameter/Value Factory Default
Multifeed
(page 132)
Specify a method for multifeed detection. Detect
multifeeds by monitoring the overlap, document
length, or the combination of both.
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
None/Check Overlapping (Ultrasonic)/Check
Length/Check Overlapping and Length
Length (When [Check Length] is specified:
Select from 10/15/20 mm)
None
Length: 10 mm
Page Edge Filler (ADF)
(page 127)
Specify a width for the margin around the
scanned image to fill the margin in white.
This setting can also be configured in the
scanner driver. In that case, Page Edge Filler of
the scanner driver is used on the output image.
Top/Left/Right: 0 to 15 mm
Bottom: -7 to 7 mm
(in increments of 1)
(A: image, B: filled area, A+B: output)
Top/Bottom/Left/
Right: 0 mm
Dropout color
(page 128)
Select a color to be removed from the scanned
image (only available in black & white or
grayscale mode).
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
Red/Green/Blue/None Green
Document check area specification
for Multifeed Detection
(page 134)
Selected range: Select this item to restrict the
area to detect multifeed.
[Selected range] check box Not selected
Enable/Disable (Middle): Specify whether to
enable or disable multifeed detection in the
selected area.
Enable/Disable
(When [Selected range] is selected)
Disable
Start (Middle): Specify the start position of the
area in length (mm) from the leading edge of the
document.
0 to 510 mm (in increments of 2) 0 mm
End (Middle): Specify the end position of the area
in length (mm) from the leading edge of the
document.
0 to 510 mm (in increments of 2) 0 mm