Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
19
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section explains how to power on/off the scanner.
How to Turn the Power ON
1 Press the [Power] button on the operator panel.
The scanner is turned on, and the [Power] button lights in green.
During initialization, the Function Number Display on the operator
panel changes in the following order: "8" "P" "0" "1". The
scanner is ready when the Function Number Display shows "1".
1.3 Turning the Power ON/OFF
HINT
The method by which the scanner is powered on/off can be specified
from one of the following:
Press the [Power] button on the operator panel
Use an AC power strip to control power supply for peripherals such
as a scanner in accordance with the computer's power.
Turn on/off the scanner in accordance with the computer's power.
For details, refer to "Method of Turning the Scanner ON/OFF [Power
SW Control]" (page 140).
HINT
When the [Power] button is pressed, the LED indicator lights for a
moment. Note that it is due to an initial diagnosis and not a failure.
To Next Page
Loading...
