Fujitsu Fi-7030 - An Error (E or Other Letter or Number) Is Already Displayed in the Function Number Display after Power-On

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
93
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
An error ("E" or other letter or number) is already
displayed in the Function Number Display after
power-on.
Is the error code still displayed after you turned the power
off then back on?
No
The scanner is operating correctly.
Yes
Is the letter "c" flashing on the Function Number Display
while the LED indicator is flashing?
Yes
Close the ADF firmly.
For details, refer to "1.4 Opening/Closing the ADF" (page 21).
If the indication does not return to the ready status ("1") after you closed the ADF,
check the items in "7.4 Before You Contact the Scanner Service Provider" (page
104) first, then contact your FUJITSU scanner dealer or an authorized FUJITSU
scanner service provider.
No
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 104) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.