Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
34
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
Contents
How to Load Documents
1 Pull out the chute extensions according to the length of
the documents.
For details, refer to "1.5 Setting Up the ADF Paper Chute (Feeder)"
(page 22).
2 Bring down the stacker and slide out the stacker
extension towards you according to the length of the
documents.
For details, refer to "1.6 Setting Up the Stacker" (page 23).
3 Load documents in the ADF paper chute (feeder).
Load the documents face-down in the ADF paper chute (feeder).
4 Adjust the side guides to the width of the documents.
Do not leave space between the side guides and the documents.
Otherwise, the documents may be fed skewed.
5 Scan the documents with the image scanning application.
For details, refer to the image scanning application manual.
ATTENTION
Remove all paper clips and staples.
Reduce the number of sheets if a multifeed or pick error occurs.
To Next Page
Loading...
