Fujitsu Fi-7030 User Manual

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
89
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
Image quality is poor.
*1: The scanned image may differ from the original image significantly if you simply "binarize" (output in black & white) a picture or a photo.
Did you configure the settings in the scanner driver to scan
in black & white mode?
Yes
Configure the scan settings that do not "binarize" (output in black and white) in the
scanner driver, and then perform a scan. (*1)
No
Are the glass sections inside the ADF clean?
No
Clean the inside of the ADF.
For details, refer to "Chapter 5 Daily Care" (page 62).
Yes
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 104) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.

Fujitsu Fi-7030 Specifications

General

Optical Resolution	600 dpi
ADF Capacity	50 sheets
Interface	USB 2.0
Duplex Scanning	Yes
Scanner Type	ADF (Automatic Document Feeder)
Supported Paper Size	A4, A5, A6, B5, B6, Letter, Legal
Scanning Method	Color
Scan Speed (Color, A4, 200 dpi)	30 ppm / 60 ipm
Power Consumption	Operating: 18 W or less
Scanning Speed	30 ppm / 60 ipm
Daily Duty Cycle	Up to 4, 000 sheets